|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|
[Feb.-2017-New]Valid Braindump2go CompTIA N10-006 Exam PDF 1521q Offer[444-453]
2017 Feb. New CompTIA Network+ N10-006 Exam Dumps and N10-006 Exam Questions Updated Today!
Which spanning-tree protocol rides on top of another spanning-tree protocol?
D. Mono Spanning Tree
Which two statements about IPv6 router advertisement messages are true? (Choose two.)
A. They use ICMPv6 type 134.
B. The advertised prefix length must be 64 bits.
C. The advertised prefix length must be 48 bits.
D. They are sourced from the configured IPv6 interface address.
E. Their destination is always the link-local address of the neighboring node.
Which three statements about IPv6 prefixes are true? (Choose three.)
A. FF00:/8 is used for IPv6 multicast.
B. FE80::/10 is used for link-local unicast.
C. FC00::/7 is used in private networks.
D. 2001::1/127 is used for loopback addresses.
E. FE80::/8 is used for link-local unicast.
F. FEC0::/10 is used for IPv6 broadcast.
After you configure the Loopback0 interface, which command can you enter to verify the status of the interface and determine whether fast switching is enabled?
A. Router#show ip interface loopback 0
B. Router#show run
C. Router#show interface loopback 0
D. Router#show ip interface brief
Which three statements about link-state routing are true? (Choose three.)
A. Routes are updated when a change in topology occurs.
B. Updates are sent to a multicast address by default.
C. OSPF is a link-state protocol.
D. Updates are sent to a broadcast address.
E. RIP is a link-state protocol.
F. It uses split horizon.
Which NAT function can map multiple inside addresses to a single outside address?
What is the first step in the NAT configuration process?
A. Define inside and outside interfaces.
B. Define public and private IP addresses.
C. Define IP address pools.
D. Define global and local interfaces.
What are two requirements for an HSRP group? (Choose two.)
A. exactly one active router
B. one or more standby routers
C. one or more backup virtual routers
D. exactly one standby active router
E. exactly one backup virtual router
Which two commands can you enter to verify that a configured NetFlow data export is operational? (Choose two.)
A. show ip flow export
B. show ip cache flow
C. ip flow ingress
D. ip flow egress
E. interface ethernet 0/0
F. ip flow-export destination
What are three characteristics of satellite Internet connections? (Choose three.)
A. Their upload speed is about 10 percent of their download speed.
B. They are frequently used by rural users without access to other high-speed connections.
C. They are usually at least 10 times faster than analog modem connections.
D. They are usually faster than cable and DSL connections.
E. They require a WiMax tower within 30 miles of the user location.
F. They use radio waves to communicate with cellular phone towers.
1.|NEW N10-006 Exam Dumps (PDF & VCE) 1521Q&As Download:
2.|NEW N10-006 Study Guide: